DIY: Character 3D Model

One of my newly found favorite books are The Sister Grimm series. When we were given an assignment last December to make a 3-D Model of the main character of any book of our choice, I immediately thought of Puck, a fairy in The Sisters Grimm series. Puck is a four thousand year old fairy, who decided to remain as an eleven year old boy with a shabby appearance. He is white with blond hair and green eyes, and goes by the alias of The Trickster King. He enjoys pulling pranks on everyone, especially on Sabrina Grimm, and has a huge ego. He thinks of himself as the ultimate villain even though he is kindhearted.

Materials/Tools Needed:

Clay (assorted)
Aluminum Foil
Wood (to stand the character)
Krazy Glue (to glue the feet onto the wood, wings, and sword)
Wire
Wire Cutters
Pliers (to twist the wire)
Power Drill and Drill Bits (for the holes on the wood)
Popsicle stick (for the wooden sword)
Precision Knife/Blade

Step by step:

Using a wire, create a stick figure body(without a head)
Cut tiny strips on aluminum foil and wrap around the wire to give it thickness. Try and give it the thickness that you need so that you do not use too much clay
Flatten some clay and start wrapping around the figure (clothes, shoes, and other accessories). We started with the neck area, then the shirt, pants and then hands and shoes. We used the wire exposed at the neck to hold it while applying the clay and shaping it
Shape the head, give it hair, eyes, ears, nose, and stick it onto the wire (neck)
Cut 2 pieces of wire for the wings and wrap them in clay. Leave the tips exposed since they will get inserted into the character’s back and glued in place
Bake in oven for about 25 minutes at 275 degrees F
Let clay cool completely
Remove the wire stand and touch up any defects. Make the wooden sword using the popsicle stick and cut to size. We cut the handle and glued the sword on the top part of the hand and part of the hilt on the bottom part to make it look like he is holding it.
Use the drill to make 2 holes onto the wood base, 1 for each leg. Cut 2 small pieces of wire and insert them onto the holes with part of it sticking out. Drill a small hole on the bottom of each foot making sure they align to the base. Apply krazy glue on the wood and set the feet. Hold in place until the glue sets. Do the same for the wings